Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Owner's Manual / Driver assistance / Assist / Interrupting cruise control

Audi A6 Typ 4G: Interrupting cruise control

Applies to: vehicles with Audi adaptive cruise control

Assist
Fig. 96 Selector lever

Requirement: adaptive cruise control must be switched on.

Overriding cruise control

  • To accelerate manually, pull the lever toward you into position 2 and hold it there. The message ACC: override appears. Or
  • press the accelerator pedal.
  • To resume cruise control, release the lever or take your foot off the accelerator pedal.

Canceling cruise control while driving

  • Move the lever into position 3. The message ACC: standby appears. Or
  • press the brake pedal.
  • To resume the stored speed, move the lever into position 2.

Canceling cruise control when stopped

  • Push the lever away from you into position (3).

    The message ACC: standby appears.

  • To resume cruise control, press the brake pedal and pull the lever toward you into position (2).

WARNING

It is dangerous to activate cruise control and resume the stored speed when the current road, traffic or weather conditions do not permit this. This increases the risk of an accident.

    READ NEXT:

     Setting the distance

    Applies to: vehicles with Audi adaptive cruise control Fig. 97 Operating lever: setting the distance Tap the switch to display the current set distance fig. 97. To increase or reduce the distance

     Audi braking guard

    Applies to: vehicles with Audi adaptive cruise control Fig. 99 Instrument cluster: approach warning The braking guard uses radar sensors and a video camera. It also functions within the limits of the

     Messages

    Applies to: vehicles with Audi adaptive cruise control Braking guard: Off This message appears if the system is switched off through the Infotainment system. Otherwise, if the system is turned off, th

    SEE MORE:

     Battery Jump Start Terminal

    Overview - Battery Jump Start Terminal 1 - Cable Holder Quantity: 2 2 - Nut 40 Nm For wiring harness bracket 3 - Nut Tightening specification. Refer to → Wiring diagrams, Troubleshooting & Component locations. 4 - Wiring Guide With ho

     Tire Pressure Monitoring System

    Tire Pressure Monitoring with Pressure Sensor   WARNING If tire sealant was used, then the wheel electronics on that particular wheel must be replaced. The wheel electronics, that is, the system pressure sensor, forms a physical unit with the valve.   Note The lettering on the wheel e

    © 2011-2025 Copyright www.aa6.tochrfr.com