Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Owner's Manual / Driver assistance / Parking systems / Adjusting the display and the warning tones

Audi A6 Typ 4G: Adjusting the display and the warning tones

Applies to: vehicles with parking system plus/rearview camera/ peripheral camera

The display and warning tones can be adjusted in the Infotainment.

  • Select: the [CAR] function button > (Car) Systems control button > Driver assistance > Parking aid.

Display

On - An optical display is shown for the parking system plus, a rearview camera image is shown for the rearview camera.

Off - When the parking system is switched off, only audible signals are given.

Signal tones

Front volume - volume for the front area

Rear volume - volume for the rear area

Front frequency - frequency for the front area

Rear frequency - frequency for the rear area

Music volume during nav. prompts - the volume of the audio/video source is lowered when the parking system is turned on.

The newly selected level is demonstrated briefly by the sound generator.

Tips

  • The warning tones can also be adjusted directly by the visual display or the picture from the camera. Simply press the Settings control button.
  • Changed settings are activated when the parking system is switched on again.
  • The settings for volume and frequency are automatically saved and assigned to the remote control key being used.

    READ NEXT:

     Error messages

    Applies to: vehicles with parking system plus/rearview camera/ peripheral camera There is an error in the system if the LED in the button is blinking and you hear a continuous alarm for a few second

     Trailer hitch

    Applies to: vehicles with parking system plus/rearview camera/ peripheral cameras and trailer hitch For vehicles using the trailer socket, the parking system rear sensors are not activated when you sh

     Intelligent Technology

    SEE MORE:

     Roof End Strip, Removing and Installing

    Special tools and workshop equipment required Pry Lever -80-200- Omega Clip Tool -T40280- Removing - Carefully unclip the rear roof panel trim -1- in the center off the roof frame using the Pry Lever -80-200--arrow-. Installing Install in reverse order of removal. Note the following: -&n

     Overview - Wheel Bearing

    1 - Nut 40 Nm Always replace if removed 2 - Upper Front Control Arm 3 - Upper Rear Control Arm 4 - Bolt Always replace if removed 5 - Washer 6 - Wheel Bearing Housing Removing and installing. Refer to → Chapter "Wheel Bea

    © 2011-2026 Copyright www.aa6.tochrfr.com