Audi A6 Typ 4G: General, Technical data
READ NEXT:
Final Drive Identification
Final Drive Identification, 0BC
The 0BC rear final drive unit is used with the following
transmissions:
6-Speed Manual Transmission 0B2 All Wheel Drive (AWD)
6-Speed Man
1 - Transmission
2 - Driveshaft
Overview. Refer to
→ Chapter "Overview - Driveshaft".
Removing and installing. Refer to
→ Chapter "Driveshaft, Removing and Inst
Pay attention to the following to avoid personal injury and
vehicle damage:
WARNING
Risk of injury and accident by accidentally engaging
a gear with the engine running.
Shift the transmissi
SEE MORE:
Seals Component Location Overview, 0BC, 0BD
1 - Right Ring
Replacing. Refer to
→ Chapter "Flange Shaft Protective Ring, Replacing".
2 - Right Seal
Replacing. Refer to
→ Chapter "Right Seal, Replacing".
3 - Left Seal
Replacing. Refer to
→
The Level Control System Control Module -J197- is behind the
luggage compartment side trim panel on the right side.
Removing
- If the control module is being replaced, then select
"replace" control module on the Vehicle Diagnostic Tester in
Guided Functions.
- Follow the prompts on the s
Identification
