Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Owner's Manual / Starting and driving / Lights and Vision / Turn signal and high beam lever

Audi A6 Typ 4G: Turn signal and high beam lever

The turn signal lever operates the turn signals, the high beams and the headlight flasher.

Lights and Vision
Fig. 38 Turn signal and high beam lever

Turn signals

The turn signals activate when you move the lever into a turn signal position when the ignition is switched on.

  1. right turn signal
  2. left turn signal

The turn signal blinks three times if you tap the lever (convenience turn signal).

High beams and headlight flasher

Move the lever to the corresponding position:

Move the lever to the corresponding position:

  1. high beams on (vehicles with High beam assistant)
  2. high beams off or headlight flasher

The indicator light in the instrument cluster turns on.

WARNING

High beams can cause glare for other drivers, which increases the risk of an accident. For this reason, only use the high beams or the headlight flasher when they will not create glare for other drivers.

    READ NEXT:

     High beam assistant

    Applies to: vehicles with high beam assistant A camera on the rearview mirror mount can detect light sources from other road users. The high beams switch on or off automatically depending on the posit

     Adjusting the exterior lighting

    The functions ore adjusted in the Infotainment system. Select: [CAR] function button > (Car) Systems control button > Vehicle settings > Exterior lighting. Automatic headlights You can a

     Interior lighting

    Front and rear interior lighting Fig. 40 Front headliner: interior lighting controls Fig. 41 Rear headliner: Reading light Press the corresponding button fig. 40: - Interior lighting on/off - Do

    SEE MORE:

     Horn

    Overview - Horn 1 - Screw Tightening specification: Refer to → Body Exterior; Rep. Gr.63; Front Bumper; Overview - Impact Member 2 - High Tone Horn -H2- For vehicles with a TDI engine Removing and installing. Refer to → Chapter "High Tone Horn -H

     Information Electronics Control Module 1 -J794-, Removing and Installing

    Information Electronics Control Module 1 -J794-, Removing and Installing Special tools and workshop equipment required Fiber-Optic Repair Set - Connector Protective Caps -VAS 6223/9-. The Information Electronics Control Module 1 -J794- is located inside the instrument panel.   Note If re

    © 2011-2025 Copyright www.aa6.tochrfr.com