Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Owner's Manual / Driver assistance / Assist / Changing the speed

Audi A6 Typ 4G: Changing the speed

Applies to: vehicles with Audi adaptive cruise control

Assist
Fig. 95 Operating lever: changing the speed

  • To increase or reduce the speed in increments, tap the lever up or down.
  • To increase or decrease the speed quickly, hold the lever up or down until the red LED (A) reaches the desired speed fig. 94.

After each change, the new stored speed appears briefly in the information line fig. 94 D.

Driving in stop-and-go traffic

Applies to: vehicles with Audi adaptive cruise control

The adaptive cruise control system also assists you in stop-and-go traffic.

Stopping automatically

If an object ahead stops, your vehicle will brake and stay at a stop, within the limits of the system.

The Start/Stop system can be used as usual.

Driving manually

  • Tap the accelerator pedal, or
  • pull the lever toward you into position 2.

Tips

If an obstacle is detected when your vehicle starts moving, the driver intervention request appears. Your vehicle will drive more slowly when starting. This may also happen in some situations when there is no apparent obstacle.

    READ NEXT:

     Interrupting cruise control

    Applies to: vehicles with Audi adaptive cruise control Fig. 96 Selector lever Requirement: adaptive cruise control must be switched on. Overriding cruise control To accelerate manually, pull the le

     Setting the distance

    Applies to: vehicles with Audi adaptive cruise control Fig. 97 Operating lever: setting the distance Tap the switch to display the current set distance fig. 97. To increase or reduce the distance

     Audi braking guard

    Applies to: vehicles with Audi adaptive cruise control Fig. 99 Instrument cluster: approach warning The braking guard uses radar sensors and a video camera. It also functions within the limits of the

    SEE MORE:

     Front Passenger Airbag

    Overview - Front Passenger Airbag 1 - Nut 9 Nm Quantity: 2 Replace 2 - Connector For Front Passenger Airbag Release Valve Igniter -N491-   WARNING Replace the connector after the airbag has deployed. Refer to → Electrical Equipment General Informati

     Overview - Wheel Bearing

    1 - Nut 40 Nm Always replace if removed 2 - Upper Front Control Arm 3 - Upper Rear Control Arm 4 - Bolt Always replace if removed 5 - Washer 6 - Wheel Bearing Housing Removing and installing. Refer to → Chapter "Wheel Bea

    © 2011-2026 Copyright www.aa6.tochrfr.com