Audi A6 Typ 4G: Completing AdBlue refill
Applies to: vehicles with selective catalytic reduction
Closing the filler neck
After filling
The vehicle must be driven so that the system
recognizes that the AdBlue was refilled. This can
take several minutes.
- If there was no AdBlue left in the tank and a
range of 0 mi (0 km) was shown in the display,
switch the ignition on for about 30 seconds before
starting the engine.
Tips
AdBlue can freeze at very low temperatures.
If this happens, the system will not detect that the AdBlue was refilled and it
will continue to inform you of the low AdBlue level. The message turns off as
soon as the tank thaws
out again.
READ NEXT:
Applies to: vehicles with gasoline engine
It is very important that your emission control
system (catalytic converter) is functioning properly
to ensure that your vehicle is running in on
environmenta
Applies to: vehicles with diesel engine
The diesel particulate filter filters nearly all of
the soot particles out of the exhaust. The filter
cleans itself automatically under normal driving
condition
Working in the engine compartment
Special care is required if you are working in the
engine compartment
For work in the engine compartment, such as
checking and filling fluids, there is a risk of inju
SEE MORE:
Seat Pan Cover and Cushion, Separating
Special tools and workshop equipment
required
Upholstery Clip Pliers -VAG1634-
Removing
- Remove seat cover with seat cushion for seat pan. Refer to
→ Chapter "Seat Pan Cover and Cushion, Removing and Installing".
- Remove the seat cover -1
Fuel filler neck
The fuel filler neck is located on the right rear
side panel behind the fuel filler flap.
If the power locking system should fail, you can
still open the flap manually - for detailed instructions.
You can find the fuel tank capacity of your vehicle.
The label on the inside of the