Audi A6 Typ 4G: Opening/closing the hood
The hood is released from inside the vehicle.
.56.png)
Fig. 180 Driver footwell: release lever
.57.png)
Fig. 181 Rocker switch under the hood
Make sure the wiper arms are not raised up from
the windshield. Otherwise the paint could be
damaged.
Opening the hood
- With the driver's door open, pull the lever below
the instrument panel in the direction of the
arrow
fig. 180.
- Raise the hood slightly
.
- Press the rocker switch under the hood upward
fig. 181. This releases the
catch.
- Open the hood.
Closing the hood
- Push the hood down until you override the
force of the strut.
- Let the hood fall lightly into the latch. Do not
press it in.
.
WARNING
- Never open the hood when there is steam or
coolant escaping from the engine compartment,
because there is a risk that you could
be burned. Wait until no steam or coolant is
escaping.
- For safety reasons, the hood must always be
closed securely while driving. Because of
this, always check the hood after closing it
to make sure it is latched correctly. The
hood is latched if the front corners cannot
be lifted.
- If you notice that the hood is not latched
while you are driving, stop immediately and
close it, because driving when the hood is
not latched increases the risk of an accident.
READ NEXT:
The most important check points.
Fig. 182 Typical location of the reservoir and the engine oil filler opening
jump start point (-) with hex head screw
jump start point (+) under a cover
Engine oi
Engine oil specifications
The engine oil used must conform to exact specifications.
The service interval display in the instrument
cluster of your vehicle will inform you when it is
time for an oil ch
The engine in your vehicle depends on an adequate
amount of oil to lubricate and cool all of
its moving ports.
In order to provide effective lubrication and cooling
of internal engine components, all
SEE MORE:
Removing
- Fold both rear seat backrests forward.
- Remove the screen separator -1-
to the right from out of the mounts -2-
on the right 2/3 of the rear seat backrest.
Installing
Install in reverse order of removal. Note the following:
- Position the screen separator -1-
and the mo
Regardless of the child restraint that you use,
make sure that it has been certified to meet Safety
Standards and has been certified by its manufacturer
for use with an airbag. Always be sure that the child restraint is properly
installed at
one of the rear seating positions. If in exceptional
circ