Audi A6 Typ 4G: Rear Final Drive, Differential
READ NEXT:
Overview - Driveshaft, Mounted On Transmission Side
Note
Pay attention to the general repair information. Refer to
→ Chapter "Repair Information".
The attached driveshaft can only be
Driveshaft, Removing and Installing, Driveshaft Connected on
Transmission Side
Special tools and workshop equipment
required
Transmission Support -VW785/1B-
Counterhold - Kit - Multiple Use -T101
Driveshaft on Transmission, Removing and installing, Driveshaft Bolted
on Transmission Side
Special tools and workshop equipment
required
Counterhold - Kit - Multiple Use -T10172- with adapters
C
SEE MORE:
Overview - Steering Column, Manual
1 - Bolt
30 Nm
Always replace if removed
The threaded hole for the bolt must always be cleaned (for example,
using a thread tap).
Install the bolt first, then pull on the steering intermediate shaft
several time to make sure it is secure. Tighten
Applies to: vehicles with Start/Stop system
Fig. 80 Instrument cluster: engine switched off (stop
phase)
Brake the vehicle to a stop. The engine stops shortly before the vehicle
comes to a stop or if the vehicle is stationary. Keep your foot on the brake
pedal. The indicator light
appears
