Audi A6 Typ 4G: Storage
Cup holders
Fig. 62 Center console: front cup holder
Fig. 63 Rear armrest: rear cup holder
Front cup holders
- Tap on the cover in the center console to open
the cup holders.
Rear cup holders
WARNING
Note
Beverage containers in the cup holders should
always have a lid. If not, beverages could spill
and cause damage to vehicle equipment, such
electronics or seat covers.
Cooled glove compartment
Applies to: vehicles with cooled glove compartment
The cooled glove compartment only functions
when the A/C system is switched on.
Fig. 64 Glove compartment: switching cooling mode on/
off
- Turn the knob (A) counter-clockwise to switch
the cooling on. The symbols on the knob indicate
the correct position.
- Turn the knob (A) clockwise to switch the cooling
off.
The glove compartment cooling mode only functions
when the vehicle A/C system is switched on.
If the heating is switched on, switching the glove
compartment cooling mode off is recommended.
READ NEXT:
You will find a range of storage compartments
and holders at different locations in the vehicle.
Compartments in the doors
Compartment in the glove compartment
(cooled). The glove compartment can
Applies to: vehicles with roof rack
Fig. 65 Attachment points for the roof rack
If luggage or cargo is to be carried on the roof,
you must observe the following:
Only a specially designed roof rack
General information
WARNING
Read and follow the important safety precautions
in Storing cargo correctly.
Increasing the size of the luggage
compartment
Applies to: vehicles with folding backrests
The
SEE MORE:
Divided Rear Seat Backrest, Removing and Installing
Note
The following describes removing and installing the right
2/3 section of the backrest. Removing and installing the left
1/3 rear seat backrest is identical.
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
Overview - Headlamp Washer System
1 - Spray Nozzle for Night Vision System Camera -R212-
Removing and installing. Refer to
→ Chapter "Night Vision System Camera -R212- Spray Nozzle, Removing and
Installing".
2 - Screw
2.5 Nm
Quantity: 2
3 - Mount