Audi A6 Typ 4G: Wiring
READ NEXT:
Overview - Relay Carriers, Fuse Panels and E-Boxes
1 - Nut
3 Nm
Quantity: 2
2 - Screw
3 Nm
Quantity: 4
3 - Engine Control Module
4 - Nut
3 Nm
Quant
E-Box, Removing and Installing
Removing
- With the ignition switched off, disconnect the ground cable
from the battery. Refer to
→ Chapter "Battery, Disconnecting and Connecting".
-
Terminal 30 Wire Junction -TV2-, Removing and Installing
Removing
- With the ignition switched off, disconnect the ground cable
from the battery. Refer to
→ Chapter "Battery, Disconnecti
SEE MORE:
Overview - Front Axle
I - → Chapter "Subframe"
II - → Chapter "Suspension Strut and Upper Control Arm"
III - → Chapter "Lower Control Arm and Ball Joint"
IV - → Chapter "Wheel Bearing"
V - → Chapter "Drive Axle"
Special tools and workshop equipment
required
Wedge Set -T10383-
Removing
- Switch the ignition off and remove the ignition key.
- Remove the interior door mechanism trim. Refer to
→ Chapter "Trim Molding, Removing and Installing".
- Remove the bolts -1 to 3-.
Note
