Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Workshop Manual / Transmission / Rear Final Drive 0BC, 0BD, 0BE, 0BF / Seals / Component Location Overview - Seals

Audi A6 Typ 4G: Component Location Overview - Seals

Seals Component Location Overview, 0BC, 0BD

Seals Component Location Overview, 0BC, 0BD

1 - Right Ring

  • Replacing. Refer to → Chapter "Flange Shaft Protective Ring, Replacing".

2 - Right Seal

  • Replacing. Refer to → Chapter "Right Seal, Replacing".

3 - Left Seal

  • Replacing. Refer to → Chapter "Left Seal, Replacing".

4 - Left Ring

  • Replacing. Refer to → Chapter "Flange Shaft Protective Ring, Replacing".

5 - Input Shaft Seal

  • Replacing. Refer to → Chapter "Input Shaft Seal, Replacing".

6 - Input Shaft Ring

  • Replacing. Refer to → Chapter "Flange Input Shaft Ring, Replacing".

Seals Component Location Overview, 0BE, 0BF

Seals Component Location Overview, 0BE, 0BF

1 - Right Ring

  • Replacing. Refer to → Chapter "Flange Shaft Ring, Replacing, 0BE, 0BF".

2 - Right Seal

  • Replacing. Refer to → Chapter "Right Seal, Replacing".

3 - Left Seal

  • Replacing. Refer to → Chapter "Left Seal, Replacing, 0BE, 0BF".

4 - Left Ring

  • Replacing. Refer to → Chapter "Flange Shaft Ring, Replacing, 0BE, 0BF".

5 - Input Shaft Seal

  • Replacing. Refer to → Chapter "Input Shaft Seal, Replacing".

6 - Input Shaft Ring

  • Replacing. Refer to → Chapter "Flange Input Shaft Ring, Replacing, 0BE, 0BF".

    READ NEXT:

     Left Seal, Replacing

    Left Seal, Replacing, 0BC In this chapter "right seal, replacing" is also described. The shaft seal can be only be replaced with the final drive removed. Special tools and workshop equipment req

     Input Shaft Seal, Replacing

    Input Shaft Seal, Replacing, 0BC Special tools and workshop equipment required Puller - Multiple Use -VW391- Slide Hammer Set - Adapter 40 - VW771/40- from the Slide Hammer Set - VW771- Retainer

     Flange Shaft Protective Ring, Replacing

    Flange Shaft Ring, Replacing, 0BC The ring can only be replaced with the final drive and the flange shaft removed. Special tools and workshop equipment required Press Plate -VW401- Press Plate

    SEE MORE:

     Windshield wipers

    Switching the windshield wipers on Fig. 48 Windshield wiper lever Move the windshield wiper lever to the corresponding position:   0. windshield wipers off rain sensor mode. The windshield wipers switch on once the vehicle speed exceeds approximately 2 mph (4 km/h) and it is raining. The

     Generator

    Overview - Generator Overview - Generator, Version 1 without Bushing 1 - Screw Steel bolt 20 Nm Aluminum bolt 8 Nm +180º Replace after removal There are different versions. Refer to the Parts Catalog. Quantity: 4 2 - Generator Removing and installing. Refer to →&nb

    © 2011-2026 Copyright www.aa6.tochrfr.com