Audi A6 Typ 4G: Seals
READ NEXT:
Seals Component Location Overview, 0BC, 0BD
1 - Right Ring
Replacing. Refer to
→ Chapter "Flange Shaft Protective Ring, Replacing".
2 - Right Seal
Replacing. Refer to
Left Seal, Replacing, 0BC
In this chapter "right seal, replacing" is also described.
The shaft seal can be only be replaced with the final drive
removed.
Special tools and workshop equipment
req
Input Shaft Seal, Replacing, 0BC
Special tools and workshop equipment
required
Puller - Multiple Use -VW391-
Slide Hammer Set - Adapter 40 - VW771/40- from the Slide
Hammer Set - VW771-
Retainer
SEE MORE:
A/C Refrigerant High Pressure Switch -F23-
Note
Switch pressures, removing and installing switches as well
as switch arrangement and version. Refer to vehicle specific
refrigerant circuit
→ Heating, Ventilation and Air Conditioning; Rep. Gr.87; System
Overview - Refriger
Overview - Rear Lid Spoiler
1 - Spoiler
Removing and Installing. Refer to
→ Chapter "Rear Lid Spoiler, Removing and Installing".
2 - Two-Sided Adhesive Tape
- Remove the protective film after positioning the spoiler on the rear
lid.
3 - Removing Aid
Component Location Overview - Seals
