Audi A6 Typ 4G: Controls, Housing
READ NEXT:
Overview - Mechatronic
1 - ATF Drain Plug
Tightening specification -item 1-
2 - Seal
Replacing
3 - Bolt
Tightening specification and sequence. Refer to
→
Special tools and workshop equipment
required
Shop Crane -VAS6100-
Hook And Support Tool -T40197-
Hook and Support Tool -T40294-
DANGER!
Do not use the Hook And Support Tool T40197 for
Special tools and workshop equipment
required
Engine And Transmission Holder -VW6095-
Holding Plate -VW309A-
Hook And Support Tool -T40197-
Hook and Support Tool -T40294-
DANGER!
Do no
SEE MORE:
1 - Suspension Strut Dome
2 - Nut
30 Nm
Loosen and tighten diagonally
Always replace if removed
3 - Bolt
20 Nm
4 - Tower Brace
Removing and installing. Refer to
→ Chapter "Tower Brace, Removing and Installing".
5 - Bolt
20 Nm
Removing
- Open the cover in the luggage compartment right trim panel.
- Disconnect the control module connectors
-1-.
- Release the tab -arrow- and
remove the control module.
Installing
Install in reverse order of removal.
Engine Hood Contact Switch -F266-, Removing and Installing
Mechatronic
