Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Workshop Manual / Chassis / Suspension, Wheels, Steering / Wheels, Tires, Wheel Alignment

Audi A6 Typ 4G: Wheels, Tires, Wheel Alignment

READ NEXT:

 Axle Alignment Information

Wheel alignment must only performed using VW/Audi-approved wheel alignment equipment. Each time wheels are aligned, both front and rear wheels must be aligned. Otherwise, proper vehicle drivability

 Axle Alignment Specified Values

Axle Alignment Specified Values, Sportback Front Axle   Note The specified values apply to all engine versions. 1) On RHD vehicles, the camber must be determined based on the distance between

 Front Axle Camber, Adjusting

Camber cannot be adjusted. Camber can be centered evenly within specified tolerance range by shifting subframe. - Remove the noise insulation -1 and 2-. Refer to → Body Exterior; R

SEE MORE:

 Transmission, Removing

Transmission, Removing, Vehicles with 6-Cylinder Gasoline Engine Special tools and workshop equipment required Pry lever -80-200- Engine and Gearbox Jack -VAS6931- Tensioning Strap -T10038- Motor Transport Loop -T40016- Crankshaft Socket -T40058- Gearbox Support -T40173- M8 x 20 bolt Prepa

 Hydraulic System

General Information, Brake Fluid Brake fluid is hygroscopic, meaning that it has the ability to absorb water and moisture from the air. If water has been absorbed, the boiling point will drop, for example, during high braking temperatures the brake fluid may develop steam bubbles and cause the br

© 2011-2026 Copyright www.aa6.tochrfr.com