Audi A6 Typ 4G: Controls, Housing
READ NEXT:
Fastener Tightening Specifications
1 Replace
2 For bolt tightening
clarification, refer to
→ Chapter "Overview - ATF Circuit" and see items
-15 and 17-
Drive Axle Heat Shield - Tightening Sp
1 - Selector Lever Transmission Range Position Display Unit -Y26-
Removing and Installing, refer to
→ Electrical Equipment; Rep. Gr.96; Lamps; Selector Lever Transmissio
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
The cable ties or the assembly aid for the button on the
handle. The assembly aid is already installed at the factory
when
SEE MORE:
Left/Right HID Headlamp Control Module -J343-/-J344-, Removing and
Installing, through MY 2014
WARNING
Danger to life due to high voltage.
For work on the yellow high voltage symbol marked
areas HID headlamp must be de-energized.
Turn off the ignition and all electrical consumers
and
Model with Longitudinally Installed Engine
Tread variance for models with a longitudinally installed
engine, such as A4, A5, A6, A7, A8, Q5, Q7, ...
In this case, the variance between the front and rear axle
may not be more than 2 mm
Note
For all four wheels use only tires of the same co
