Audi A6 Typ 4G: Driving
READ NEXT:
A new vehicle must be broken in, and the break-in
distance should be 1,000 miles (1,500 km). Do
not drive at speeds that will exceed 2/3 of the
maximum permitted engine speed (RPM) for the
first 600 m
Applies to: S models
By warming up/cooling down the engine carefully,
you can help reduce unnecessary strain on
your vehicle when driving in a sporty style.
The engine speed is limited when the engin
The amount of fuel consumption, the environmental
impact and the wear to the engine,
brakes and tires depends mostly on your driving
style. With an anticipatory and economic driving
style, fuel consum
SEE MORE:
Roof Trim Molding, Removing and Installing
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
Removing
Note
Do not bend the roof trim molding.
Tape around the roof trim molding on the A-pillar to prevent
damaging the paint.
- Open the front and rear doors.
General Information
Perform a road test to determine if a vehicle pulls to one
side and if so, when and to which side. If the vehicle pulls to
one side, see procedure
→ Chapter "Corrective Action when Vehicle Pulls to One Side".
If the vehicle alignment is measured, submit the measurement
