Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Owner's Manual / Starting and driving / Driving / Stopping the engine

Audi A6 Typ 4G: Stopping the engine

  • Bring the vehicle to a full stop.
  • Move the selector lever to the P or N position.
  • Press the [START ENGINE STOP] fig. 78 button.

Steering lock

The steering locks when you turn the engine off using the [START ENGINE STOP] button and open the driver's door. The locked steering helps prevent vehicle theft.

Emergency off function

If it is absolutely necessary, the engine can also be turned off while driving in the R or D/S selector lever position at speeds below 6 mph (10 km/ h). To stop the engine, press and hold the [START ENGINE STOP] button and also press the brake pedal.

WARNING

  • Never turn off the engine before the vehicle has come to a complete stop. The full function of the brake booster and the power steering is not guaranteed. You may need to use more force when braking or steering.

    Because you cannot brake and steer as you usually would, this could lead to accidents and serious injuries.

  • Always take the key with you whenever you leave your vehicle. Otherwise, the engine could be started or electrical equipment such as the power windows could be operated.

    This can lead to serious injury.

  • For safety reasons, always park the vehicle with the selector lever in the P position.

    Otherwise, there is the risk that the vehicle could roll unintentionally.

Note

If the engine has been under heavy load for an extended period of time, heat builds up in the engine compartment after the engine is switched off and there is a risk of damaging the engine. For this reason, let the engine run at idle for approximately two minutes before shutting it off.

Tips

After the engine has been switched off, the radiator fan can continue to run for up to 10 minutes - even with the ignition switched off.

It can also switch on again after some time if the coolant temperature rises as the result of heat buildup or if the engine is already warm and the engine compartment is also heated by the sun's rays.

    READ NEXT:

     Messages

    Turn off ignition before leaving car This message appears and a warning tone sounds if you open the driver's door when the ignition is switched on. Press brake pedal to start engine This message appea

     Starting the engine when there is a malfunction

    It may not be possible to start the engine under certain circumstances, for example if the battery in the vehicle key is drained, if interference is affected the key or if there is a system malfunctio

     Start-Stop system

    Description Applies to: vehicles with Start/Stop system The Start/Stop system can help increase fuel economy and reduce CO2 emissions. In Start/Stop mode, the engine shuts off automatically when the

    SEE MORE:

     Identification

    Final Drive Identification Final Drive Identification, 0BC The 0BC rear final drive unit is used with the following transmissions: 6-Speed Manual Transmission 0B2 All Wheel Drive (AWD) 6-Speed Manual Transmission 0B4 All Wheel Drive (AWD) 7-Speed DSG Transmission 0B5 All Wheel Drive (AWD) Auto

     Ball Joint, Removing and Installing

    Special tools and workshop equipment required Torque Wrench 1332 40-200Nm -VAG1332- Torque Wrench 1332 Insert - Ring Wrench - 21mm -VAG1332/7- Puller - Ball Joint -T40010A- For a vehicle with air suspension Vehicle Diagnostic Tester Removing - Remove the control arm. Refer to → C

    © 2011-2026 Copyright www.aa6.tochrfr.com