Audi A6 Typ 4G: Front Doors, Central Locking System
- Overview - Door
- Door, Removing and Installing
- Door, Adjusting
- Inner Door Seal, Removing and Installing
- Overview - Window Regulator
- Window Regulator Motor, Removing and Installing
- Door Handle, Removing and Installing
- Bracket, Removing and Installing
- Door Lock, Removing and Installing
- Window Guide, Removing and Installing
- Component Location Overview - Central Locking
- Driver Door Control Module -J386- and Front Passenger Door Control Module
-J387-, Removing and Installing
- Vehicle Positioning System Interface Control Module -J843-, Removing and
Installing
READ NEXT:
1 - Front Door
2 - Bolt
8 Nm
3 - Seal
For the door arrester
4 - Bolt
33 Nm
5 - Cap
For the door arrester
6 - Door Arrester
R
Removing
- Disconnect the door connector on the A-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
- Remove the door arrester bolt -2-.
- Remove the cov
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Front and Rear Door Template -T40038 /14-
Use the Front and Rear Door Template -T40038 /14- on the
front door with the
SEE MORE:
Overview - Compressor, Multi-contour Seat through 08/2012
1 - Nut
3.5 Nm
Quantity: 3
Brace rubber-metal mount while tightening
2 - Spring Washer
Quantity: 3
3 - Washer
Quantity: 3
4 - Bonded Rubber Bushing
Quantity: 3
Removing and installi
Brake Rotor, Removing and Installing, Steel Brakes
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Removing
- If the same brake rotor is reinstalled with used brake pads,
remove the brake caliper. Refer to
→ Chapter "Brake Caliper, Removing and Ins
