Audi A6 Typ 4G: Hood, Lids
- Overview - Hood
- Hood, Removing and Installing
- Hood, Adjusting
- Hood Latch, Removing and Installing
- Catch, Removing and Installing
- Hinges, Removing and Installing
- Overview - Rear Lid
- Rear Lid, Removing and Installing
- Rear Lid, Adjusting
- Hood Latch, Removing and Installing
- Actuator, Removing and Installing
- Hinges, Removing and Installing
- Catch, Removing and Installing
- Rear Lid Seal, Removing and Installing
- Gas-Filled Strut, Removing and Installing
- Fuel Filler Door Unit
READ NEXT:
Overview - Hood
1 - Cover for the Right Hood Hinge
Clipped onto the side
2 - Hood
A second technician is needed to support and hold the hood during
removal and installation
Hood Impact Guard, Replacing
Note
The impact guard is also equipped with double-sided adhesive tape.
1 - Clip
2 - Impact Guard
To remove, remove the clip from the hood
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Gap Dimensions for Hood
Note
All dimensions are in mm with a +- 0.5 mm tolerance.
Dimension -A- = 4.5 mm
Di
SEE MORE:
Special tools and workshop equipment
required
Subframe Bushing Tool Kit -3301-
Bearing Installer - Control Arm -3346-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Hydraulic Press -VAS6178-
Pneumatic/Hydraulic Foot Pump -VAS6179-
Bearing Installer - Wheel Hub/Beari
Parts of the airbag system are installed at many
different places on your Audi. Installing, removing,
servicing or repairing a part in an area of the
vehicle can damage a part of an airbag system
and prevent that system from working properly
in a collision.
There are some important things you have
