Audi A6 Typ 4G: Exterior Lights, Switches
- Overview - Headlamp
- Headlamp, Removing and Installing
- Headlamp, Adjusting
- Matrix LED Headlamp, Calibrating
- Left/Right Front Turn Signal Bulb - M5- / -M7-, Removing and Installing
- Low Beam Headlamp Bulb, Removing and Installing
- Left/Right HID Headlamp Control Module -J343-/-J344-, Removing and
Installing
- Headlamp Power Output Stage, Removing and Installing
- Left/Right Headlamp Beam Adjustment Motor -V48-/-V49-, Removing and
Installing
- Headlamp Fan, Removing and Installing
- Fog Lamp
- Exterior Rearview Mirror Lamps
- Exterior Door Handle Lamps
- Sill Panel Strip Lamps
- Overview - Body Tail Lamps
- Overview - Rear Lid Tail Lamps
- Tail Lamp, Removing and Installing
- Rear Lid Tail Lamp, Removing and Installing
- Bulb Holder, Removing and Installing
- Tail Lamp, Correcting Installed Position
- High-Mounted Brake Lamp
- License Plate Lamp
- Overview - Access/Start Authorization System
- Overview - Keyless Access Authorization System
- Front Exterior Door Handle Switch, Removing and Installing
- Access/Start System Antennas, Removing and Installing
- Rear Lid Opener Control Module -J938-, Removing and Installing
- Steering Column Switch Module
- Parking Aid
- Parallel Parking Assist
- Parallel Parking Assist
READ NEXT:
Overview - Headlamp, Halogen Headlamps
1 - Headlamp Housing
USA: the front side marker lamp bulb is an LED and is integrated in
the headlamp housing. The LED cannot be replaced. The ent
Headlamp Housing, Removing and Installing, Halogen Headlamp
Removing
- Turn the light switch to position "0".
- Remove the front bumper cover. Refer to
→ Body Exterior; Rep. Gr.
Headlamp, Adjusting
The following test and adjustment description applies to all
countries.
However, national guidelines or regulations of the country
should be observed.
LED Headlamp, Adjusting
SEE MORE:
Brake Caliper, Removing and Installing, Steel Brakes
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts catalog prior to
starting procedure.
Mandatory Re
Trailer Hitch Socket, Removing and Installing - Version 1
Removing
- Turn off the ignition and remove the key.
- Remove the bolts -arrows-.
- Detach the socket from the retaining plate.
Socket with Rear Fog Lamp Shut-Off Contact Switch -F216-:
- Remove harness connector -2-
for