Audi A6 Typ 4G: Exterior Equipment
- Overview - Radiator Grille
- Radiator Grille, Removing and Installing
- Overview - Spoiler
- Spoiler, Removing and Installing
- Overview - Trim Molding and Covers
- Overview - Sill Panel Trim
- Overview - B-Pillar Trim
- Overview - Wheel Covers
- Trim Molding, Removing and Installing
- Sill Panel Trim, Removing and Installing
- B-Pillar Door Trim, Removing and Installing
- Wheel Covers, Removing and Installing
- Floor Heat Shield, Removing and Installing
- Noise Insulation
- Overview - Underbody Panels
- Underbody Panels, Removing and Installing
- Decorative/Protective Film
- Exterior Rearview Mirror
- Overview - Front Wheel Housing Liner
- Front Wheel Housing Liner, Removing and Installing
- Rear Wheel Housing Liner, Removing and Installing
- Name Badges and Emblems
- Trailer Hitch
READ NEXT:
Overview - Radiator Grille, Audi A6/S6 through MY 2014
1 - Audi rings
Removing and installing. Refer to
→ Chapter "Front Emblem, Removing and Installing, Audi A6/allroad/S6".
2&
Radiator Grille, Removing and Installing, Audi A6/allroad/S6 through MY
2014
Removing
- Remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
-
Overview - Rear Lid Spoiler
1 - Spoiler
Removing and Installing. Refer to
→ Chapter "Rear Lid Spoiler, Removing and Installing".
2 - Two-Sided Adhesive Tape
- Re
SEE MORE:
Your vehicle is equipped with a front "Advanced
Airbag System" in compliance with United States
Federal Motor Vehicle Safety Standard (FMVSS)
208, as well as Canada Motor Vehicle Safety
Standard (CMVSS) 208 as applicable at the time
your vehicle was manufactured.
The Advanced Airbag system in your
Washer Fluid Reservoir Filler Tube, Removing and Installing
Special tools and workshop equipment
required
Drip Tray
Removing
- Place a drip tray under the windshield washer fluid
reservoir.
- Remove the plenum chamber cover. Refer to
→ Body Exterior; Rep. Gr.50; Bulkh
